Nationally AIM Compliant
Under 200 G/L
Crosslinked Oxidative System
Clear wood coating/varnish
Excludes SCAQMD
Rymar Exotic Forest Wood Coating is a special blend of tung oil, supreme linseed oil and other proprietary resins that help penetrate the surface of exotic hardwood and softwoods. With these special oils and advanced sunscreens, Rymar Exotic Forest Wood Coating will stand the test of time.
IMPORTANT INFORMATION
Rymar Exotic Forest Wood coating is a slow drying penetrating coating when used on dense hardwood. It is recommended that only one coat be applied to these types of woods. Additional coats should be applied when needed. When applying on horizontal surfaces brush out thoroughly and allow several days for product to penetrate and dry. Over application will result in prolonged dry times and possible product failure on all types of woods.
DIRECTIONS
Wood should be clean and dry. It is receommended that Rymar Rinseable Soap be used to clean the wood before sealing. If using bleach do not allow it to remain on the surface for more than five minutes. Between coats, clean with Rymar Rinseable Soap and water, no bleach. Do Not Use Metal Pails or Hard Water. Ask your dealer about preparing surfaces for coatings; they may be able to advise you otherwise depending on your situation. A coat should be applied as soon as project is completed providing the wood is at a moisture content of 15% or less. If it is higher than 15% wait approximately three to six weeks before application. A second coat may be applied in 60 days after the first coat or when ever necessary. MAINTENANCE COATS SHOULD BE DONE AS NEEDED. Do not allow sealer to puddle. End grain on all wood should be sealed. Coating may be applied with a bristle brush or by spraying and then back brushing. Be sure to shake well before using and stir thoroughly during use. IF USING MULTIPLE BATCH NUMBER, MIX THEM TOGETHER BEFORE APPLYING.
NOTE! Do a test: Try a brushout on your project to ensure the color is what you want before doing your entire project. Clear will not prevent graying as well as pigmented coatings.
MAINTENANCE: For continued performance a coat of Rymar Exotic Forest Wood Coating should be applied every 18 to 24 months. In some cases Rymar Exotic Forest Wood Coating may need to be applied more often depending on weather conditions, substrate conditions, project preparation and application.
WARRANTY
Rymar warrants that the contents of this can are not defective. In the event this product fails to comply with the warranty it is Rymar LLC's option to furnish replacement of product or a refund of the purchase price with proof of purchase. In the event of product failure and or misuse of this product, Rymar and its affiliates assume no responsibility (implied or otherwise), for labor, substrate, other items or materials used in either the application of this product or otherwise.
PRODUCT SPECIFICATIONS
Restrictions: Apply when air and surface temperature are above 65 degrees and below 90 degrees
Weight Per Gallon: 7.77
Solids by Weight: 55
VOC: Under 350 G/L
Paintable: No
Flashpoint: 105 degrees
Type: Clear wood coating/Varnish
Vehicle: Solvent
Finish: Satin
Colors: 4
Containers: 1 gallon, 5 gallons
Coverage: Approximately 300-400 square feet per gallon, depending on porosity of wood.
Drying Time: Approximately 1 to 7 days depending on temperature, 30 days to full cure. All times are temperature and moisture dependent .
Clean up: Mineral Spirits
Application: Bristle brush, sprayer
Reduction: None
Cure: Air Dry
Substrate: Wood
NOTE: Do A Test: All colors shown on Mahogany. A brushout must be done on your project to ensure color and product satisfaction before doing your entire project.
